Table of Contents
Advertisement
Entering Mission Critical Geofence
When the radio enters the predefined Geofence area,
the radio displays <Geofence Alias> with intelligent
backlight and the user hears a Voice Announcement.
Zone and channel alias of the Geofence area is
displayed. If the radio is set to manual, the user can
choose either to proceed with zone and channel
change or cancel the change.
The radio then connects to the designated talkgroup.
The radio displays the talkgroup alias and dynamic
regroup tone sounds. The transmit power level
changes and the radio shows a direct text message
content without any user operation.
Note:
Depending on how your radio is programmed,
you may or may not be alerted by Voice
Announcement (VA), TMS display, Intelligent
Backlight, and the Transmit Power Level. The
user will be alerted only if these indicators are
configured in the radio. The VA can be
programmed to alert continuously or
momentarily.
116
English
Note:
If Site Selectable Alert (SSA) is enabled, the
radio mutes any alert that is received when
entering the Geofence area and unmutes
when exiting.
Exiting Mission Critical Geofence
When the radio exits the Geofence area, the radio
reverts to the original transmit power level, intelligent
lighting, channel or newly assigned talkgroup. Voice
announcement is cancelled or the user hears a pre-
programmed VA tone. The radio displays the new
channel and a message is received to indicate the
changes.
Trunking System Controls
Operating in Failsoft System
The failsoft system ensures continuous radio
communication during a trunked system failure. If a
trunking system fails completely, the radio goes into
failsoft operation and automatically switches to its
failsoft channel.
During failsoft operation, your radio transmits and
receives in conventional operation on a
Advertisement
Table of Contents
