Table of Contents
Advertisement
Initiating a Quick Call II Transmission
The broadcasting or transmitting radio must be pre-
programmed to see the tone in the Quick Call II tone
list. The receiving radio must also be pre-
programmed to decode the tone to broadcast.
1
or to QCII, and press the Menu Select button
directly below QCII.
or
to select the tone to broadcast.
2
3 Press the PTT to broadcast the selected tone, or
press and hold the PTT to broadcast the selected
tone and transmit with your vocal transmission.
You hear the radio sounds the selected tone. You
can begin your call after the tone ends.
4 Release PTT to listen.
Emergency Operation
The Emergency feature is used to indicate a critical
situation.
If the Top (Orange) button is preprogrammed to send
an emergency signal, this signal overrides any other
communication over the selected channel.
Your radio supports the following Emergency modes:
•
Emergency Alarm
•
Emergency Call (Trunking Only)
•
Emergency Alarm with Emergency Call
•
Silent Emergency Alarm
Check with your dealer or system administrator for
more information on the programming of this feature.
Only one of the Emergency modes above can be
assigned to the preprogrammed Emergency button
or the Emergency footswitch.
Note:
To exit emergency at any time, press and hold
the preprogrammed Emergency button for
about a second. This timer is programmable
from 0 – 6250 milliseconds by a qualified
technician.
Sending an Emergency Alarm
This feature allows you to send a data transmission,
which identifies the radio sending the emergency, to
the dispatcher.
79
English
Advertisement
Table of Contents
