Storage; Disposal; Troubleshooting; Technical Specifications - Silvercrest 273265 Operating Instructions Manual

BB&3(B)ROLHQVFKZHLVVJHUDHWB%ERRN 6HLWH 0RQWDJ  'H]HPEHU    
9.2

Storage

WARNING! Risk of material damage!
~ During storage, the lid|11 must not be
locked, but only loosely closed. Perma-
nent locking could damage sealing
rings|10 and|16.
• Figure C: wind the power cable|6
around the cable spool|17 at the un-
derside of the device.
• Store the device protected against dust
and dirt and out of the reach of chil-
dren.

10. Disposal

The symbol showing a wheel-
ie bin crossed through indi-
cates that the product
requires separate refuse col-
lection in the European Un-
ion. This applies to the
product and all accessories marked with this
symbol. Products identified with this symbol
may not be discarded with normal house-
hold waste, but must be taken to a collection
point for recycling electric and electronic ap-
pliances. Recycling helps to reduce the con-
sumption of raw materials and protect the
environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.

11. Troubleshooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
~ Do not attempt to repair the device
yourself under any circumstances.
Possible causes /
Fault
• Has the device been
No function connected to the power
supply?
• Ensure that the film is po-
sitioned smoothly be-
tween the sealing strip|9
Seams are and the welding
not tight wire|14.
• The film was damp or
contaminated at the
seam.
12. Technical specifica-
tions
Model: SFS 110 B2
Mains voltage: 220-240 V ~50/60 Hz
Protection class: II
Power rating: 110 W
Operating at least 80 seconds after
pause: each use
Subject to technical modification.
Action
9
GB