Cleaning And Storage; Cleaning - Silvercrest SV 125 A1 Operating Instructions Manual

positioned just before the rear reference
ridges 11 and the side reference ridg-
es 13.
4. Ensure again that there are no creases
in the film bag - especially in the area
above the welding wire 15.
5. Close the lid 10.
6. Use both hands to press firmly on the
edges of the lid 10. They must audibly
click into place.
7. Press the button
up. The film bag is first vacuum-packed
and then sealed.
The LED goes out when the process is
complete.
NOTE: if the LED 3 does not go out and the
noise of the vacuum pump does not stop, de-
spite the fact that no further air is being
sucked out of the film bag, cancel the pro-
cess. Check that the film bag is in the correct
position in the device, and check for leaks.
8. Simultaneously, press buttons 7 in order
to release the lock of the lid 10.
9. Open the lid 10 and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
3. The LED lights

9. Cleaning and storage

DANGER! Risk of injury
through burning/scalding!
Allow the device to cool down com-
pletely before you clean it or put it
away.
The welding wire 15 becomes very hot
during operation. Do not touch the hot
welding wire 15.
DANGER! Risk of electric
shock!
Prior to cleaning, disconnect the mains
plug 4 of the device.
DANGER! Risk of electric
shock due to moisture!
The device and the power cable with
mains plug 4 must not be immersed in
water or other liquids.
WARNING! Risk of material dam-
age!
Do not use any sharp or abrasive clean-
ing agents.

9.1 Cleaning

In order to ensure the proper function and
the full capacity of your device, clean it reg-
ularly.
• Wipe down the housing of the device
with a damp cloth.
• Prior to the next use, the device must be
completely dry.
Collector
1. Grasp the centre or both outer ridges
with your fingers and carefully lift the
collector for liquids 16 out upwards.
2. Drain the liquid.
3. Rinse the collector 16 under warm dish-
water or place it in the dishwasher.
Make sure it is dry before inserting it.
11
GB