Parameter Configuration; Serial At Command Configuration; Udp Remote Configuration - Ebyte E103-W03 Product Instruction Manual

Cc3220r 2.4ghz wifi serial port module

Hide thumbs Also See for E103-W03:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

E103-W03 User Manual

6.3 Parameter configuration

Serial AT command configuration, directly open the serial debugging assistant, and set the corresponding baud rate, data

bits, etc.

Configure according to the AT command in Chapter 6. It should be noted that the command must follow the

specification.

During remote configuration, it is necessary to ensure that the module and the PC are in the same local area network. For

the configuration method, see the communication with the PC (either make the module in AP mode, the PC is connected

to the module, or the module is in STA mode and the PC is connected to the same router) to obtain the IP After the

address, directly enter the IP address and UDP port number 8009 (this port number is a fixed value and cannot be

changed). In essence, remote configuration is also an AT command operation. For specific commands, see AT commands.

Table of Contents