Table of Contents
Advertisement
Safety
Introduction
Adjusting the Belt Tension
1
2
Product Overview
Installation
4
5
Operation
3
230 ft-lb
311 N∙m
|
82
90
Maintenance
Troubleshooting
Use the illustrations and instructions to adjust the
air clutch belt tension. Adjustment is only needed if
the belt is loosened or removed to service other
system components.
Note: Certain components have been removed
from the illustrations to provide a clear view
of the equipment.
Moving Parts
• Rotating parts can cause
severe injury or death.
• Do not enter or reach into
the compartment when
equipment is operating.
1 Remove the top half of the belt guard.
2 Loosen the screw on the back of the idler
plate.
3 Turn the adjustment screw clockwise to
increase the belt tension or counterclockwise
to decrease the belt tension.
4 Set the belt tension to allow for 1/4 to 5/16 inch
deflection when 10 to 12 lbf are applied to the
longest span.
Note: Do not over-tighten the belt. Extremely
high tension can reduce belt life and
damage other drive components.
5 Tighten the idler plate screw to hold the
adjustment block in position.
6 Install the top half of the belt guard.
Advertisement
Table of Contents
