Table of Contents
Advertisement
Safety
Introduction
Adding the Compressor Oil
Product Overview
1
3
Installation
Operation
2
|
77
90
Maintenance
Troubleshooting
Use the illustrations and instructions to add oil to
the sump. Purge the pressure from the system
before adding the oil. Use ISO 68 low-foaming or
anti-foam hydraulic oil.
High Pressure
• Liquid ejected at high
pressure can cause
serious injury.
• Purge all pressure before
servicing.
1 When all pressure has been purged from the
system, remove the oil fill cap.
2 Add oil to the compressor, then run the
compressor for 10 seconds to circulate the oil
through the system.
Note: After pouring some oil into the
compressor, allow it to settle before
adding more to avoid over-filling.
3 Add oil until it reaches halfway up the sight
glass.
4 Install the oil fill cap.
Advertisement
Table of Contents
