Videx 4000 Series Manual page 6

4000 Series
Art. 4304
Speaker unit with built-in camera
Art. 4304X
Speaker unit with built-in camera & proximity key reader
REPROGRAMMING A MASTER TAGS
If the master tag is lost or damaged, a new one can be programmed using the following procedure:
1. Switch off the power.
2. Open the external module housing.
3. Bridge the PTE and GND terminals or press and hold down the "press to exit" button, if this
is wired to the external module (refer to the external module's instructions).
4. Switch the power back on.
↪ The external module emits a high-pitched "beeping" sound.
5. Remove the short between the PTE and GND terminals or release the "press to exit" button.
↪ The external module emits a high-pitched "beeping" sound.
6. Place the master tag in front of the tag reader.
↪ The external module emits two high-pitched "beeping" sounds, then two low-pitched
"beeping" sounds, the master tag is programmed, all user tags have been deprogrammed
and the external module exits programming mode.
7. Close the external module's housing.
HOW TO REMOVE/INSERT THE CARD NAME HOLDER
• To avoid damage to the module front plate, mask the side that
will be in contact with the screwdriver blade;
• Insert the screwdriver (flat side) into the card-holder hole as
shown in Fig. 8;
• Move the screwdriver to the left as shown in Fig. 9 to extract
the card name holder;
• Edit the card name then replace it inside the holder and refit:
insert the holder inside its housing from the left or right side
then push the other side until it clips into place.
ADHESIVE GASKET PLACEMENT
seal as shown in Fig. 10.
Apply the
Y
ANTI-TAMPERING LOCKS FIXING
Fit the anti-tampering locks
Art. 4304/4304X -
Installation instructions
as shown in Fig. 11.
W
Fig. 8
Y
Fig. 10
- 6 -
4304-0
4304-1
4304-2
4304X-0
4304X-1
4304X-2
STEEL
ALI
MATTE
R 0.1
GUN METAL
Made in Italy
BIP
BIP
BIP BIP
BIP BIP
Fig. 9
G
Fig. 11
66251857 - V1.6 - 30/11/22
ON
1 2 3 4 5 6 7 8
RS485
EXPANSION
BUTTONS
W