Table of Contents
Advertisement
Before using for the first time
en
KBefore using for the first
time
Before you can use your new appliance, you must
t h e f i r s t t i m e
B e f o r e u s i n g f o r
make some settings. You must also clean the cooking
compartment and accessories.
Before using for the first time
Before using the appliance for the first time, enquire
about the water hardness of your tap water from your
water supplier.
So that the appliance can reliably remind you to
decalcify it when required, you must correctly set your
water hardness range.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Notes
If your water is very hard, we recommend that you
■
use softened water.
If you only use softened water, you can set the water
■
hardness range to "softened" in this case.
If you use mineral water, set the water hardness
■
range to "4 very hard".
If you use mineral water, you must only use non-
■
carbonated mineral water.
Water hardness range
0
1 (up to 1.3 mmol/l)
2 (1.3 - 2.5 mmol/l)
3 (2.5 - 3.8 mmol/l)
4 (above 3.8 mmol/l)
Initial use
After connecting the appliance to the power or following
a power cut, the settings for initial use are shown on the
display. It may take a few seconds for the instruction to
appear.
You can change these settings at any time in the
Note:
basic settings. ~ "Basic settings" on page 26
Setting the language
The language is the first setting displayed. "German" is
the preset language.
Turn the rotary selector to set the required language.
1.
Touch the next text field to confirm.
2.
The next setting appears.
14
Setting
00 softened
01 soft
02 medium
03 hard
04 very hard
Setting the clock
The clock starts at "12:00".
Touch the "Clock" text field.
1.
Set the clock using the rotary selector.
2.
Touch the next text field to confirm.
3.
The next setting appears.
Setting the water hardness
The default water hardness setting is "very hard".
Use the rotary selector to set the water hardness.
1.
Touch the "Complete the settings" text field to
2.
confirm.
A note appears in the display confirming that the initial
use has been completed.
Switch the appliance off using the ÿ On/Off button if
you do not need to use it.
Calibrating the appliance and cleaning the
cooking compartment
The boiling point of water depends on the air pressure.
During calibration, the appliance sets itself to the
pressure ratio at the installation location. This occurs
automatically during the first steam operation. This
results in a lot of steam.
Preparing the calibration
Remove the accessories from the cooking
1.
compartment.
Remove leftover packaging, such as polystyrene
2.
pellets, from the cooking compartment.
Before calibrating the appliance, wipe the smooth
3.
surfaces in the cooking compartment with a soft, wet
cloth.
Calibrating the appliance and cleaning the cooking
compartment
Notes
The calibration can only be started once the cooking
■
compartment is cold (room temperature).
Do not open the appliance door during calibration.
■
Calibration will otherwise be interrupted.
Press the ÿ On/Off button to switch on the
1.
appliance.
Fill the water tank.
2.
Set the specified type of heating, temperature and
3.
duration for the calibration, then start the appliance
operation.
Settings
Type of heating
Temperature
Duration
Steaming
100 °C
30 minutes
Advertisement
Table of Contents
