Table of Contents
Advertisement
en Before using for the first time
To place the accessory at shelf positions with pull-
3.
out rails, pull out the pull-out rails.
Wire rack
Place the accessory so that it is in-
or baking
serted on the rear stop of the pull-out
tray
system.
Note: The pull-out rails lock in place when they are
fully pulled out. Gently push the pull-out rails back
into the cooking compartment.
Push the accessory all the way in, making sure that
4.
it does not touch the appliance door.
Note: Take any accessories that you will not be using
out of the cooking compartment while the appliance is
in operation.
Combining accessories
You can combine the wire rack with the universal pan
to catch any liquid that drips down.
Before using for the first time
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
7.1 Performing initial start-up
After connecting the appliance to the power supply,
you must configure the settings for its initial start-up. It
may take a few minutes for the settings to appear on
the display.
Press
to switch the appliance on.
1.
a The first setting appears.
To change the setting as required, press a value in
2.
the list or change the value using the setting ring.
Possible settings:
– Language
– Home Connect → "Home Connect ", Page 18
– Time
→ "Setting the time", Page 18
Press
and switch to the next setting.
3.
Work through the settings and make changes as re-
4.
quired.
a After the last setting, a message appears on the dis-
play confirming that the initial start-up is complete.
To check the appliance before heating for the first
5.
time, open and close the appliance door once.
7.2 Cleaning the appliance before using it
for the first time
Before using the appliance to cook food for the first
time, you must clean the cooking compartment and ac-
cessories.
10
Place the wire rack on the universal pan so that
1.
both spacers
are on the rear edge of the univer-
sal pan.
Insert the universal pan between the two guide rods
2.
for a shelf position. In so doing, the wire rack is on
top of the upper guide rod.
Wire rack
on univer-
sal pan
6.3 Other accessories
You can purchase other accessories from our cus-
tomer service, specialist retailers or online.
You will find a comprehensive range of products for
your appliance in our brochures and online:
www.bosch-home.com
Accessories are appliance-specific. When purchasing
accessories, always quote the exact product number (E
no.) of your appliance.
You can find out which accessories are available for
your appliance in our online shop or from our customer
service.
Remove the product information and the accessor-
1.
ies from the cooking compartment. Remove any
leftover packaging, such as polystyrene pellets, and
any adhesive tape that is in or on the appliance.
Wipe the smooth surfaces in the cooking compart-
2.
ment with a soft, damp cloth.
Press
to switch the appliance on.
3.
Apply the following settings:
4.
Type of heating
Temperature
Cooking time
→ "Basic operation", Page 11
Start the operation.
5.
Ventilate the kitchen while the appliance is heat-
‒
ing.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
6.
Press
to switch the appliance off.
Once the appliance has cooled down, clean the
7.
smooth surfaces in the cooking compartment with a
detergent solution and a dish cloth.
Clean the accessories thoroughly using a detergent
8.
solution and a dish cloth or soft brush.
3D hot air
Maximum
1 hour
Advertisement
Table of Contents
