Subscribe to Our Youtube Channel
Related Manuals for Silverline ASK SL3461-60 SR
Summary of Contents for Silverline ASK SL3461-60 SR
- Page 1 Assembly instructions HOOD USER GUIDE ENGLISH ASK SL3461-60 SR ASK SL3461-90 SR Read this manual prior to performing any task!
- Page 2 MANUFACTURER Merzifon OSB AMASYA, Silverline IMPORTER Jilmas Group Nordic ApS Eli Christensens Vej 90, 7430 Ikast Denmark Telephone: +45 70104014 Fax: +45 70131389 E-mail: info@silverline.dk Internet: www.silverline.dk 1, en_US © SILVERLINE 22.02.2023 HOOD USER GUIDE ENGLISH...
-
Page 3: Table Of Contents
Table of contents Table of contents Technical Drawing..................4 WARNING AND SAFETY PRECAUTIONS..........6 2.1 LETHAL RISK, DANGER OF POISONING......... 8 USAGE WITH AND WITHOUT CARBON FILTER........13 3.1 CARBON FILTER REPLACEMENT..........14 CLEANING AND PREVENTIVE MAINTENANCE........15 4.1 ALUMINIUM FILTER CLEANING............15 4.1.1 Washing in Dishwasher.............. -
Page 4: Technical Drawing
Technical Drawing Technical Drawing 22.02.2023 HOOD USER GUIDE ENGLISH... - Page 5 Technical Drawing Fig. 1 22.02.2023 HOOD USER GUIDE ENGLISH...
-
Page 6: Warning And Safety Precautions
WARNING AND SAFETY PRECAUTIONS WARNING AND SAFETY PRECAU- TIONS WARNING AND SAFETY PRECAU- Make sure that the installation place allows the user to easily TIONS unplug the power cable in case of This appliance can be used by any danger. children of 8 years and older, Do not touch your product's lamps people with physical, sensory or... - Page 7 WARNING AND SAFETY PRECAUTIONS Do not use non-fire-resistant fil- If the feeder cable is damaged, it tering materials instead of the must be replaced by its manufac- filter. turer or its authorized technical service or any other personnel Do not operate your product qualified at the same level, in without filter, and do not remove order to avoid any dangerous sit-...
-
Page 8: Lethal Risk, Danger Of Poisoning
WARNING AND SAFETY PRECAUTIONS LETHAL RISK, DANGER OF POISONING This warning does not apply to uses without flue. DANGER! When electric cooker hood is used simultaneously with devices that Warning - Death Hazard use gas or other fuels, there must There are life-threatening be sufficient ventilation in the room danger and poisoning danger... - Page 9 WARNING AND SAFETY PRECAUTIONS LETHAL RISK, DANGER OF POISONING Therefore, adequate fresh air ingress must always be WARNING! ensured.Fig. 3 Fire danger! – The oil residue in the grease filter may catch fire.Clean the grease filter at least once every 3 months.Never operate the Fig.
- Page 10 WARNING AND SAFETY PRECAUTIONS LETHAL RISK, DANGER OF POISONING aged or burned for this reason. Never operate two DANGER! gas cookers longer than 15 Danger of physical injury! minutes on high flame set- ting. A large burner over – During the installation, 5kW (Wok) has the power there is a danger of phys- of two gas burners.
- Page 11 WARNING AND SAFETY PRECAUTIONS LETHAL RISK, DANGER OF POISONING WARNING! WARNING! Dangers of fire and physical Risk of burn, risk of electric injury! shock! – Allow the appliance to cool In case of repairing that is not before cleaning or mainte- performed according to the nance process.
- Page 12 WARNING AND SAFETY PRECAUTIONS LETHAL RISK, DANGER OF POISONING NOTICE! CAUTION! When the bulbs of the device Damage hazard due to corro- malfunction, switch off the cir- sion. Always run the appliance cuit breaker and unplug the to prevent condensate forma- tion while cooking.
-
Page 13: Usage With And Without Carbon Filter
USAGE WITH AND WITHOUT CARBON FILTER USAGE WITH AND WITHOUT CARBON FILTER Ventilated air mode You can use this appliance in exhaust air mode and venti- lated air mode. Absorbed air is cleaned by the grease filters and an active carbon filter, and then it is Exhaust air mode transferred back to the... -
Page 14: Carbon Filter Replacement
USAGE WITH AND WITHOUT CARBON FILTER CARBON FILTER REPLACEMENT 3.1 CARBON FILTER REPLACEMENT CARBON FILTER Fig. 6 The device you have purchased is suitable for use with carbon filter. 1-Place the carbon filter in its housing.Fig. 6 2-Rotating the carbon filter clock- wise, ensure that it is completely fit.Fig. -
Page 15: Cleaning And Preventive Maintenance
CLEANING AND PREVENTIVE MAINTENANCE ALUMINIUM FILTER CLEANING CLEANING AND PREVENTIVE MAIN- TENANCE moisture and vapour generated in the kitchen. Clean the metal CAUTION! grease filters about every three months, under normal use condi- Cleaning and user maintenance tions (1 to 2 hours a day). of the appliance shall not be Do not use excessively effective, performed by unattended chil-... -
Page 16: Washing In Dishwasher
CLEANING AND PREVENTIVE MAINTENANCE ALUMINIUM FILTER CLEANING > Hand Wash 4.1.2 Hand Wash Clean the aluminum grease fil- ters periodically every 3 For stubborn dirts, you can use months. a special grease solvent. You can buy such an agent from the authorized sales centre. -
Page 17: Appliance Position
APPLIANCE POSITION Recommendations for Energy Saving APPLIANCE POSITION Fig. 8 When the installation of the hood is complete, the distance between the bottom surface of the hood and the top surface of the hob should be at least 500 mm for electric hobs and at least 700 mm for gas or other fuel-fired hobs (Fig. - Page 18 APPLIANCE POSITION Recommendations for Energy Saving Use your product according to its normal speeds. Use at higher speed would cause an increase in the energy con- sumption. 22.02.2023 HOOD USER GUIDE ENGLISH...
-
Page 19: Content Of Package
CONTENT OF PACKAGE CONTENT OF PACKAGE Fig. 9 Product Ø6mm Plastic Dowel Inner Flue 3.9x22 Flue Connection Plate Outer Flue Screw 4.8x50 Wall Mount Screw Flue Connection Plate Ø8mm Plastic Dowel 10- Flue Flap 3.5x9.5 Sheet Metal Screw 11- User Manual 22.02.2023 HOOD USER GUIDE ENGLISH... -
Page 20: Overview Of Hood
OVERVIEW OF hood OVERVIEW OF hood Fig. 10 1- Inner Flue 2- Outer Flue 3- Control Panel 4- Side Suction Plate/Glass 5- Cooker Lighting 22.02.2023 HOOD USER GUIDE ENGLISH... -
Page 21: Installation
Installation Installation Checking the Wall Wall must be flat, straight and have sufficient bearing capacity. Depth of drilling holes must comply with the length of bolts. The nuts and dowels provided are suitable for brick walls. For other construction material (e.g. drywall, plate, porous concrete), suitable fixing dowels and nuts shall be used. - Page 22 Installation Draw a mid location line from the ceiling perpendicular to the lower edge of the hood (Fig. 12). There is a tab in the middle of the flue connection plate. Place the middle point of this tab on the line that is drawn perpendic- ular to the wall.
- Page 23 Installation Device Preparation Open the filter cover. Remove the metal oil filter. 4,8x50 mm Fig. 13 Hold the device by its body and attach it to the hanger screws that you have previously screwed into the wall and tighten the hanger screws (Fig. 13). Fix the device to the wall with one 4.8x50 screw through the mounting hole on the inside of the device (Fig.
-
Page 24: Installing Sheet Metal Flues
Installing Sheet Metal Flues Installing Sheet Metal Flues Fig. 14 Installing the Air Outlet Connection Fix one end of the air outlet pipe directly to the air outlet area. Fix the other end of the air outlet pipe to the air outlet on the product. -
Page 25: Use Of Product
USE OF PRODUCT 3 Spd Touch Product Usage USE OF PRODUCT 10.1 3 Spd Touch Product Usage All active functions operated prior to activation of timer func- tion will be deactivated after 15 Fig. 15: Touch Button minutes. When this button is pressed, All active functions operated product will operate at speed after activation of timer function... -
Page 26: Replacing The Lamps
REPLACING THE LAMPS REPLACING THE LAMPS If the lamp of the device malfunctions, contact your dealer or customer service. Bulb Power (W) Lamp base / Socket Socket Bulb Voltage (V) 220 - 240 Size (mm) 46x46mm Energy Class 22.02.2023 HOOD USER GUIDE ENGLISH... -
Page 27: Technical Table
Technical Table Technical Table Supply Voltage 220-240V~ 50Hz Insulation Class of Motor Insulation Class CLASS I This product complies with the 2014/30/EC (Regulation on Electro- magnetic Compliance) and 2014/35/EC (Regulation on Low Voltage Devices (LVD)) Directives. This device complies with the Directive on the Control of Waste Electrical and Electronic Equipment.
Need help?
Do you have a question about the ASK SL3461-60 SR and is the answer not in the manual?
Questions and answers