Burner Reset; Oil Leak Or Fault; Power Failure; Fuel - Stanley Alpha 150K User Instructions

BURNER RE-SET
If a fault occurs on either burner then it automatically
shuts down and the red button will be illuminated. The re-
set button is located on the control panel behind the
controls panel door.
OPERATE BY PRESSING WITH FINGER ONLY
Please wait at least 60 seconds between re-setting the
burner re-set button.
If for example the storage tank has been replenished after
the oil supply ran out, and re-setting the lockout button
does not light the burner immediately, it will be necessary
to repeat the sequence.
Continuous lockouts indicate a burner or oil supply failure.
The fault should be diagnosed and rectified.
In the event of repeated failure switch off the oil and
electrical supply to the appliance and contact your
installer/service engineer.

OIL LEAK OR FAULT

If an oil leak or fault exists or is suspected the unit must
be isolated from the oil and electrical supply. The
appliance must not be used until the fault has been
rectified.

POWER FAILURE

In the event of power failure your appliance will become
in-operative. When the power is restored it will
automatically re-start, if programmed or manually set to
do so.
Please endeavour to see that when your fuel is being
delivered into your storage tank, that the appliance is left
off during delivery, and preferably for a period of 1 hour
afterwards to allow sediment within the tank to settle.
This is particularly important for oil systems using a two
pipe flow and return.
Also endeavour to avoid running out of fuel, by seeing that
the storage tank is replenished in good time. This will help
avoid nuisance breakdowns which can result through fuel
starvation.

VENTILATION

Please see that the permanent ventilation provided for the
safe and reliable operation of your is never blocked off.

FUEL

FIG. 8
P
With normal use a boiler/cooker annual flueway clean and
burner maintenance should be carried out immediately
before the end of the heating season.
An additional flueway clean halfway through the season
may be necessary in some cases - see servicing
instructions.
A HOT APPLIANCE CANNOT BE SERVICED.
Both cooker and boiler thermostat knobs should be turned
OFF the night preceding the day of the servicing so that
the appliance will have cooled down by the following
morning.
SUGGESTIONS TO PREVENT
OPERATING PROBLEMS
1. Do not allow the appliance to exceed its service
interval, the appliance must be serviced once
annually.
2. Do not alter burner settings after your service engineer
has adjusted it. It will reduce efficiency of the appliance
and be more costly to run.
3. If the appliance is to be shut down for long periods,
then switch off the electricity supply. Close all fuel
isolation valves, and arrange for your service engineer
to clean and service the appliance.
11
DESN 514807

SERVICING