Mount The Hub; Equipment Required - HP AdvanceStack Hub-8U J2610B Hardware Installation And Reference Manual

Installing the Hub
3. Check the LEDs on the hub's front panel.
4. After the hub has passed its self-test, you are ready to mount

3. Mount the hub

The HP AdvanceStack Hub-8U can be placed on a desk or mounted on any
vertical or horizontal surface, for example, a wall or under a desk.
To locate the hub on a table or other horizontal surface, no special tools are
necessary. Be certain to pick a sturdy table in an uncluttered area. You may
want to secure the hub's cables to the leg of the table to prevent people from
tripping over them.

Equipment Required

To mount the hub on a wall or under a desk, you will need the following
equipment:
1-6
When the hub is powered on, it performs a self-diagnostic test.
During the test, all LEDs are lit for a short time.
When the self-test completes successfully, the following events occur:
• the Power LED stays on
• the twisted-pair Port LEDs enter their normal operating state
• If an HP Transceiver module is installed, the AUI/Xcvr LED
stays lit
A Port LED stays on if link beat has been detected at the port. A Port
LED turns off if link beat is not detected. If you have an optional HP
AdvanceStack 8U/16U SNMP Module installed, the Port LEDs have
additional meanings. See the documentation accompanying the
module for more information. If all of the Port LEDs stay on and you
have not connected end nodes to these ports, the hub has failed its
self-test. See chapter 2, "Troubleshooting" for information about
diagnosing your hub.
the hub. Before mounting the hub, unplug it.
two number 6 by half-inch or M3 x 12 mm pan head wood screws
(not included with the hub)
a Phillips (cross-head) screwdriver (not included with the hub)