Wall Mount Hardware; Wall Mount Procedure - HP procurve radio port 220 Installation And Getting Started Manual

N o t e
Wall Mount
Wall mounting consists of hanging the ProCurve Radio Port 220 along its width
or length using the pair of wide-shoulder mounting screws provided, and
mounting slots on the bottom of the unit. The ProCurve Radio Port 220 can
be mounted onto any wood, plaster, or cement wall surface using the provided
wall anchors when necessary. The illustration shows a vertical mount.

Wall Mount Hardware

Two Phillips pan head self-tapping screws
Two wall anchors
Safety wire (recommended) and security cable (optional)
In the event that the original mounting screws are lost, the following screws
can be used instead: ANSI Standard) #6-18 X 0.875in. Type A or AB Self-
Tapping Screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-
Tapping Screw

Wall Mount Procedure

1. If the antennas being used with the Radio Port 220 require special mount-
ing provisions or mounting locations, mount these antennas in their
desired locations first, using the appropriate mounting hardware provided
with the antenna. Antenna mounting position is the most critical element
of Radio Port installation. If necessary, the mounting location of the Radio
Port 220 should be adjusted to ensure that the antenna leads from the
antenna mounting location can reach it.
Installation Instructions
11