Device Identifier; Warranty; Safety Laws - INIM Electronics SmartLoop Installation Manual

2.14

Device identifier

Figure 3 - Overview
Product category: Fire Alarm Control Panel
Model: SmartLoop
Year of Manufacture: 2007
2.15

Warranty

INIM Electronics s.r.l. warrants the original purchaser that for a period of 24 months from the date of
final acceptance, the product shall be free of defects in materials and workmanship. The warranty
applies only to defects in parts and workmanship relating to normal use. It does not cover:
• Improper use or negligence
• Damage caused by fire, flood, wind or lightning
• Vandalism
• Fair wear and tear
Inim Electronics s.r.l. shall, at its option, repair or replace any defective products. Improper use, that
is, use for purposes other than those mentioned in this manual will void the warranty. For the full
details and conditions regarding the warranty, refer to the purchase order.
2.16

Safety laws

The aim of the instructions in this section is to ensure that the device is installed and handled
properly. This chapter contains vital information. The installer should be familiar with this section and
bring each item to the attention of the system users.
2.16.1 Compliancy
The design and manufacture of the SmartLoop panel comply with EN 54-2 Fire detection and signaling
systems - Control and signaling panels.
The design and manufacture of the power supply comply with EN 54-2 Fire detection and signaling
systems - Power supply devices.
2.16.2 Managing electronic devices
The normal motions of any person may generate electrostatic potential of thousands of volts.
Discharge of this current through semiconductor devices during handling may cause serious damage
which although may not be immediately evident may reduce the reliability of the circuits.
If located in their housings, the electronic circuits of INIM Electronics products are highly immune to
electrostatic discharge.
12
Installation Manual
General information