Table of Contents
Advertisement
GB
SAFETY REGULATIONS
1.19
WORK AT ELECTRICAL COMPONENTS
Unplug the power plug from the outlet before carrying out
any repair work.
1.20
SETUP ON AN UNEVEN SURFACE
The front end must always point downwards in order to avoid
sliding away.
If possible do not use the unit on an inclined surface since the
unit tends to wander through the resulting vibrations.
42
Super Finish 33 PRO
2
GENERAL VIEW OF APPLICATION
2.1
APPLICATION
Super Finish 33 Pro is an electric driven unit for the airless at-
omization of different painting materials. Also it is able to feed
the internal feeded paint roller, which is available as accessory.
Super Finish 33 Pro is made for jobs in the workshop and on
the building site.
The device output of the Super Finish 33 Pro is designed so
that it can be used to process dispersions for small and large
objects, as well as for corrosion and flame protection.
When painting, the device is suitable for all kinds of typical
painting jobs, e.g.:
doors, door frames, balustrades, woodencladding, fences, ra-
diators (heating) and steel parts.
We recommend using the top container for paintwork.
2.2
COATING MATERIAL
Dilutable lacquers and paints or those containing solvents,
two-component coating materials, dispersions, latex paints,
façade paints, roof and attic coatings, fire and corrosion pro-
tection material.
No other materials should be used for spraying without WAG-
NER's approval.
Pay attention to the Airless quality of the
coating materials to be processed.
The unit is able to process coating materials with up to
25,000 mPas. If highly viscous coating materials cannot be tak-
en in or the performance of the unit is to low, the paint must
be diluted in accordance with the manufacturer's instructions.
Attention: Make sure, when stirring up with
motor-driven agitators that no air bubbles
are stirred in. Air bubbles disturb when spray-
ing and can, in fact, lead to interruption of
operation.
2.2.1
COATING MATERIALS WITH SHARP-EDGED
ADDITIONAL MATERIALS
These particles have a strong wear and tear effect on valves
and tips, but also on the heating hose and spray gun. This im-
pairs the durability of these wearing parts considerably.
2.2.2
TWO-COMPONENT COATING MATERIAL
The appropriate processing time must be adhered to exactly.
Within this time rinse through and clean the unit meticulously
with the appropriate cleaning materials.
Advertisement
Table of Contents
