the power set as the radio's power output setting. This is so the signal is
perfectly clean for digital operation and to avoid the radio overheating. This is
normal procedure for digital modes.
■ You can add clamp-on ferrite RF chokes to the USB data cable and the ACC
cable if you experience any stray RF getting from the radio into the PC. For
better performance, loop the wire through and then around and through the clip-
on ferrite choke again - then clamp it shut. Additional wire passes through the
ferrite choke improve filtering.
The USB-Serial port should be configured on your PC as 19200 bps, 8data bits,
no parity, 1 stop bit.
Digital Mode Connections
When using the DE-19 one cable goes from the DE-19 to the PC's USB port, one to the ACC
port and one lead to the COMM port on the head unit.
43