Engine Oil Replacement - Vari Adela 190 Instructions For Use Manual

will not suffer excessive wear. The exchange interval can be extended up to 130 hours with
oils of higher grades (API GL – 5, SAE 80W – 90). The running-up period of 5 hours must
be observed.
Czech oils fully meeting the requirements are MOGUL TRANS 90 or MOGUL TRANS
80W-90.
Oil replacement should be made when the box is warm and oil is easy to drain.
1. Clean around the oil plugs. Underlay the machine and secure it so that a space is created
under the machine for a vessel to collect oil.
2. Loosen the pour-in plug on the rear wall of the box and the drain plug in the bottom of
the gearbox (spanner No. 19).
3. After the oil has been drained, screw back the drain plug in the bottom of the box. Fill the
gearbox with the new oil (it is advised to use a funnel with flexible tubing). Oil level
should reach to the lower edge of the hole. Then screw the pour-in plug back. If the seals
under the plugs are damaged, replace them with new ones.
Figure 4: Oil plugs

6.1.2 Engine oil replacement.

See the operating manual for engine. To drain oil, the machine should be either tilted
to the side with the pour-in neck with oil gauge, or the engine should be dismounted from
the machine (see Chapter 6.4, items a),b),d) ).
BDR-595 GMI Adela 190
Plug to pour oil into the
gearbox
Plug to drain oil from the gearbox
15