Table of Contents
Advertisement
7. Slide the apron with the holder (21) into a holder in the frame above the right mudguard
and secure it by tightening the plastic rosette
Figure 2: Machine assembly
13
11
12
15
16
6
10
21
22
14
5.2 Putting the machine into operation.
The machine may be delivered without engine fillings (in dependence on different
national regulations)!
First thoroughly read the instruction for engine use! You can prevent a possible
damage to the engine.
1. Check oil volume in the engine and/or fill the engine with the prescribed oil grade and
volume. Fill the tank with the prescribed amount and type of petrol.
2. Move the accelerator lever into the front position („CHOKE"). Start the engine by
pulling on the manual starter (instructions for starting see guidelines for engine use).
3. Let the new or cold engine running on choke for about 30 seconds (accelerator lever in
the „CHOKE" position), then move the accelerator lever into the position „MAX". In
this position let the engine running for about 30 seconds.
Do not leave the machine alone when doing this.
5.3 Starting the cutting disk.
When starting the engine, the two levers on the handlebars must be in the off
position.
10
with the bolt (22).
9
7
18
BDR-595 GMI Adela 190
8
20
19
20
17
1
5
2
3
4
Advertisement
Table of Contents
