Table of Contents
Advertisement
under the cutting disk cover will do itself a partial clearance of the excessive grass and
debris. Then drive the machine against the sward again (see Chapter 5.4).
Be very careful while lifting the machine and moving the machine backwards!
b) Engine losing speed and stalling: release both levers on the handlebars, lift the machine
front by pushing down on the handlebars and move the machine a bit backwards. Clear the
space under the cutting disk casing and spread the cut grass across the ground. Start the
engine, switch on the cutting disk drive (see Chapter 5.3) and once again drive the machine
against the sward (see Chapter 5.4).
The engine must be always switched off when clearing the space under the upper
casing!
Tilt the machine always only backwards onto the handlebars. Be very careful while
moving under the lifted machine! Secure the machine against its spontaneous
motion!
Be very careful while cleaning the space under the cutting disk casing. Cutting edges
of the blades are sharp. You should wear protective gloves or use a suitable piece of
branch etc.
6 Maintenance, care and storage.
To ensure a long-term satisfaction with our product, it must be given proper care and
maintenance. Regular maintenance of the machine will prevent its early wear ensuring at the
same time a correct functioning of all its parts.
Follow all instructions for intervals of machine maintenance and adjustments. It is
advised that you keep records on the number of machine working hours and on the
conditions in which the machine was working (for service purposes). Similarly as the current
maintenance, the after-season maintenance of the machine should be entrusted to one of our
authorized service workshops in the case that you do not trust your own technical skills.
Regarding the machine weight, all maintenance and adjustment procedures are to
be done by two cooperating persons.
6.1 Machine lubrication.
6.1.1 Gearbox oil replacement and refilling.
When replacing oils, follow the basic hygienic principles, regulations and laws on
environment protection.
The gearing works in an oil bath. Oil volume should be checked once a month (oil
plugs see Fig. 4).
Minimum grade of gear oil should be GL-4, GL-5 according to API, 90 or 80W – 90
according to SAE.
Oil replacement in a new machine is to be made after the first 5 hours of operation and
then after 100 working hours or after the end of the season. This will ensure that the gears
14
BDR-595 GMI Adela 190
Advertisement
Table of Contents
