Stopping The Machine - Vari Adela 190 Instructions For Use Manual

Note: All four main positions of the accelerator lever are arrested by means of a simple
system of stamp/projection in the lever body.
STOP position of accelerator lever
- engine stands still
MAX (hare) position of accelerator lever
– engine runs at maximum speed

5.5 Stopping the machine.

 Prior to carrying out any work in the near vicinity of the machine, switch off the
engine and wait until the cutting disk stops! Always switch the engine off before
leaving the machine!
 Never let the engine running at maximum speed or idling with the cutting disk drive
clutch released and with the released clutch of wheel drive for a long time! Machine
drive components (V-belt, belt pulley, clutch pulley, etc.) might get damaged!
If you wish to stop the machine travel, release the lever on the left handlebar grip. The
machine travel will stop but the mowing disk is still rotating. The cutting disk drive will
switch off immediately after you will have released the lever on the right handlebar grip. The
cutting disk will be stopped by the safety brake.
Engine is to be switched off by pushing the lever into the STOP position.
 In the case of any critical situation, release your hold on the handlebars
immediately. The levers will return to their zero position, the machine and the
cutting disk will come to a stop (while the engine is still running at the adjusted
revolutions; this is why it is advised to switch it off by pushing the lever into the
STOP position as soon as possible!)
12
BDR-595 GMI Adela 190
MIN (turtle) position of accelerator lever
– engine runs idle
CHOKE position of accelerator lever (for cold
engine start only) – engine runs on choke