Table of Contents
Advertisement
1. Start the engine while adhering to instructions presented in the operating manual for
engine use.
2. Set-up maximum engine revolutions by using the accelerator lever on the right handrail.
(Should the engine be cold, let it warm up at maximum revolutions for about 1 minute).
3. Grasp the left handlebar grip with your left hand. Then slowly press the lever of the
cutting disk drive clutch on the right handlebar grip with your right hand.
Press the lever slowly up to about two thirds of the stroke so that the cutting disk can
start rotating and the engine does not stall.
Starting of the cutting disk is accompanied with a partial V-belt slippage and with the
accompanying phenomena such as whistling, rattling, etc. The phenomenon usually
disappears after the belt has started properly moving.
4. After the cutting disk starts turning, press the lever fully to the handrail and hold it firm.
Note: In a new or cold engine, a few of the cutting disk starts may result in engine
stalling. The phenomenon will disappear after the engine warms up. If the disk drive cannot
be started even after the engine has got warm, follow the table presented in Chapter 6.6 for
diagnostics.
5.4 Machine travel.
The machine travel is switched on by the lever on the left handrail. Press the lever down
to the rail and the machine will immediately start moving forward. While pressing the lever
and observing the machine to move forward, you have to start walking slowly.
Be prepared to a possible slight jerk when the machine starts moving.
Figure 3: Handlebars and accelerator lever
Accelerator lever
(engine speed
adjustment)
Bowden cable of the
cutting disk brake
Bowden cable of the
cutting disk drive V-
belt tightening
pulley
BDR-595 GMI Adela 190
Lever of the cutting disk
drive clutch and brake
Right handlebar grip
Lever of wheel
drive clutch
Left handlebar grip
Bowden cable of the wheel
drive clutch
11
Advertisement
Table of Contents
