Analog Devices EVAL-AD7606SDZ User Manual page 5

EVAL-AD7606SDZ/EVAL-AD7607SDZ/EVAL-AD7608SDZ User Guide
Table 3. Link Options
Link Default Position
LK1 A
LK2 Insert
LK3 B
SL1 A
SL2 A
SL3 A
SL4 A
SL5 A
SL6 A
SL7 A
K0 to 15 Do not insert (DNI)
Function
This link is used to select the power supply source for the evaluation board.
In Position A, the board is powered with the J1 wall mounted switching supply.
In Position B, the J3 terminal block is the source.
This link is used to supply the
The EVAL-SDP-CB1Z is powered from the
LK3 is used to select the V
DRIVE
In Position A, the AD7606/AD7606-6/AD7606-4/AD7607/AD7608
In Position B, the AD7606/AD7606-6/AD7606-4/AD7607/AD7608
is needed to run the device at 200 kSPS in serial interface mode.
In Position A, the CS signal is supplied from the
In Position B, The CS SMB is selected.
In Position A, the SCLK signal is supplied from the
In Position B, the SCLK SMB is selected.
In Position A, the STBY signal is supplied from the
In Position B, the STBY SMB is selected.
In Position A, the CS signal is supplied from the
In Position B, the CS SMB is selected.
In Position A, the RESET signal is supplied from the
In Position B, the RESET SMB is selected.
In Position A, the CS signal is supplied from the
In Position B, the CS SMB is selected.
In Position A, the CONVST signal is supplied from the
In Position B, the CONVST SMB is selected.
Solder links for bypassing the U level translator.
Rev. 0 | Page 5 of 15
SDP power supply form the evaluation board
ADP7104 5 V linear regulator
source for the AD7606/AD7606-6/AD7606-4/AD7607/AD7608.
SDP terminal, J2.
SDP terminal, J2.
SDP terminal, J2.
SDP terminal, J2.
SDP terminal, J2.
SDP terminal, J2.
SDP terminal, J2.
UG-851
are supplied with 3.3 V V .
DRIVE
are supplied with 5 V V , 5 V V
DRIVE DRIVE