Figure 4 Mounting Base Separated From Sensor; Figure 5 Mounting Base Attached - Campbell MMW-005 Instruction Manual

MMW-005 Solid State Wind Sensor
__________________________________________________________________________________________
MMW-005 Guide MMW-005 Sensor
Disks
MMW-005
Mounting Base

Figure 4 Mounting Base Separated from Sensor

Using the three screws supplied with the C2410 mounting
bracket, attach the sensor base to the C2410 (Figure 5). The
screws will need to be lined up with the threaded holes located
on the mounting bracket. It is recommended to leave the
sensor cable in place, as it can slide into the notch provided at
the tip of the bracket.

Figure 5 Mounting Base Attached

Before reattaching the MMW-005 to the mounting base make
note of the Orientation mark (Figure 6) on the top of the MMW-
005. This mark will need to be orientated to True North in
order to provide an accurate measurement of wind direction. It
may be helpful with the orientation process to align the symbol
along the length of the C2410 mounting bracket.