Table of Contents
Advertisement
__________________________________________________________________________________________
Installation
4.
Water ingress:
Mounting:
Connection:
Supply voltage:
Power consumption:
Communication Output:
Baud rate:
Data bits:
Stop bits:
Parity:
The MMW-005 is mounted to either a horizontal or vertical pipe
with the use of the C2410 Mounting Bracket (Figure 3). The
C2410 can be mounted to a pipe with and outside diameter
ranging from 0.75 inches to 2.0 inches.
Figure 3 C2410 Mounting Bracket
Begin the installation process by removing the mounting base
from the MMW-005 (Figure 4). This can be done by placing
one hand under the bottom disk of the sensor. Then with your
other hand, grip the mounting base and pull it away from the
sensor.
MMW-005 Solid State Wind Sensor
interference up to a discharge
power of 600 Watt
Sealed to IP65
Vertically, free-standing
4-wire cable (0.34mm²), shielded
12 V DC +/- 10%
125 mA maximum continuous
RS-422 (NMEA 0183 protocol)
serial
4800
8
1
none
Advertisement
Table of Contents
