Dishwasher Control Section - Kenmore Ultra Wash 665.1454 Series Use & Care Manual

Table of Contents

Available languages

Quick Rinse

Use for rinsing dishes, glasses, and silverware that will not be washed right

away. Do not use detergent.

*The government energy certifications are not based on this cycle. See the Normal Wash cycle description for the government

energy certification cycle. Using the SmartWash

**No other washing and drying temperature options were selected, and it was not subject to truncated testing. Rinse aid was not

used, and there was no detergent used in the prewash.

Options

High Temp

Raises main wash temperature to improve cleaning

for loads containing tough, baked-on food.

Sani Rinse

Sanitizes dishes and glassware in accordance

with NSF International NSF/ANSI Standard 184

for Residential Dishwashers. Certified residential

dishwashers are not intended for licensed food

establishments. Only sanitizing cycles have been

designed to meet the requirements of the NSF/

ANSI 184 performance standard for soil removal

and for sanitization efficacy. There is no intention,

either directly or indirectly, that all cycles on a

NSF/ANSI 184 certified dishwasher meet the NSF/

ANSI 184 performance standard for soil removal

and for sanitization efficacy.

At end of the cycle, the sanitized indicator or word

"sanitized", on some models, will glow. If your load

did not properly sanitize, the indicator will flash at

the end of the cycle. This can happen if the cycle

is interrupted, or if the water does not reach the

required temperature. The light goes off when you

open and close the door or press CANCEL.

Heated Dry

Turns the heat element on after the wash portion

of the cycle is over. Use rinse aid with or without

the Turbo Heat Dry option for best drying results.

Plastic items are less likely to deform when loaded

in the top dish rack.

*The maximum additional water used for any combination of options is 4.8 gal. (18.2 L).

Control Lock Option

Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the Lock indicator is lit, all buttons

are disabled. The dishwasher door can still be opened or closed while the controls are locked.

To turn on the Lock:

Press and hold CONTROL LOCK for 3 seconds. The Control Lock indicator will light up. If you press any button while your

dishwasher is locked, the light flashes 3 times.

NOTE: The dishwasher cannot start if the control is locked.

To turn off the Lock:

Press and hold CONTROL LOCK for 3 seconds. The light turns off.

Cycles

® H E

cycle may increase your energy usage.

Can be

selected with

SmartWash

Pots Pans

Normal Wash

SmartWash

Pots Pans

Normal Wash

Available with

any cycle except

Quick Rinse