WAMGROUP TOREX VM Series Assembly And Main Instructions For Use And Maintenance page 29

VM
8.0 REPLACEMENT OF PARTS
7) Insert the flange in the bushing seat. Use two long screws
positioned 180 degrees from each other as centring pins,
so that the holes of the flange match the holes of the body,
prevent the flange from rotating.
8) Using a press (or the forks of a forklift) to abut the bushing-
flange unit to the body. Tighten the flange to the body by
means of the holes, and be reminded to replace the two long
screws used as pins with suitable screws to fasten the flange.
9) Repeat the steps 5.6.7.8. for the opposite side of the valve.
10) Now the valve is completely assembled.
25
TOR.VM.--.M.A.0518.EN Issue: A
05.18
2