Maintenance; Troubleshooting - BorMann BBP5130 Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

How to install the disc in 6 steps ( Pictures 2, 3, 4)

1. Before any intervention, always disconnect the power tool from the battery pack.

2. Insert the centering washer until it clicks into place.

3. Select the appropriate disk for the work to be performed. Insert and center the disc.

Warning!

Never reuse discs that were originally larger and due to wear and tear have become smaller to the point of entering this grinder. Larger discs are not designed

for high speeds of smaller grinders.

4. Pay attention to the thickness of the disc to be installed to position the tensioning nut on the correct side.

5. Lock the shaft by pressing the button and simultaneously turn the shaft until it is secured.

6. Secure the disc with the spanner wrench. Do not apply too much tightening force. This will make it difficult to remove the disc or even damage it. The rotation

of the machine is self-fixing.

Deburring and thinning operation

• When powering up, wait until the machine reaches maximum speed before starting work.

• Tilt the angle grinder according to the needs of the work, within the recommended angles. Make sure that the workpiece is securely fastened.

• Do not apply too much pressure. A decrease in rotation worsens the result and the efficiency of the roughing work. Do not generate excessive heat on the

disc and the part. Make stops.

• Hold the grinder firmly and, with proper posture, apply circular movements back and forth.

• Always use both hands, and with the auxiliary handle installed.

Pic. 5

(a): Deburring

(b): Thinning

Warning!

If, despite maintaining the correct tilt, the work starts having poor performance, it is a sign that the disc is worn out or a higher power is required. Wait for the

machine to immobilize the movement before lowering or put it down.

• Never use any liquids to perform works with this power tool.

• Do not obstruct the air vents of the machine.

• Disconnect the power tool from the battery at the end of the operation.

Never use the Spindle lock button or rest the disc on a surface to stop the movement faster.

Never touch the disc immediately after the operation as it may be hot.

If the machine is subjected to heavy and long-term use, excessive heating and activation of the thermal protection system of the battery is possible, causing a

deceleration of the machine or even a temporary stop. In this situation, wait for the batteries to cool to resume operation

This power tool has an electronic overload protection system that is activated in the event of a locking. If you notice that the system has been triggered, shut

off the machine, correct the working conditions and switch it back on. Although this system has protection, it is only activated with a full lock and the constant

drive tends to degrade the machine. Avoid exposing the equipment to such situations repeatedly.

Cutting operation

1. Hold the machine firmly and do not perform side movements to avoid fragmenting the disc.

2. Position the face or neck always behind the acting plan of the disc.

3. Always use both hands, and with the auxiliary handle installed. Follow the cut in the direction in which the disc makes the downward movement; the sparks

and particles created by the cut will be projected downwards. Never use cutting disc for deburring.

Charging instructions

Please refer to the following pages.