Replacing The Power Cable; Technical Data; Cleaning And Maintenance - BorMann BAG2300 Original Instructions Manual

.
Use only grinding and cutting wheels that are
approved for a minimum speed of 6,300 rpm and
a peripheral speed of 80 m/sec.
.
Check the direction of rotation when you use
diamond cutting wheels. The directional arrow on
the diamond cutting wheel must point in the
direction in which the tool rotates.
8.6 OPERATING MODES
8.6.1 Cutting Metal
.
For cutting metal, always work with the
protection guard for cutting.
When cutting, work with moderate feed, adapted
to the material being cut. Do not exert pressure
onto the cutting disc, tilt or oscillate the machine.
Do not reduce the speed of running down cutting
discs by applying sideward pressure.
The machine must always work in an
up-grinding motion. Otherwise, the danger exists
of it being pushed uncontrolled out of the cut.
When cutting profiles and square bar, it is best
to start at the smallest cross section.
8.6.2 Rough grinding
For the best rough grinding results, hold the
grinding wheel at an angle of between 30° and
40° to the workpiece surface and guide back and
forth over the workpiece in steady movements.
It is prohibited to use the machine on
asbestos materials!
Never use a cutting wheel for rough
grinding.

9. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.

10. Technical data

Mains voltage:
Power input:
Idling speed:
Max. wheel diameter:
Mounting spindle thread:
Protection class:
L sound pressure level:
pA
L sound power level:
WA
Vibration a :
h,AG
Weight:

11. Cleaning and maintenance

Always pull out the mains power plug before
starting any cleaning work.
11.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
11.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
23
230 V ~/50 Hz
2300 W
6300 rpm
230 mm
M14
II /
96,03 dB(A), k=3 dB
107,03 dB(A), k=3 dB
2
8,438 m/s , k=1,5 m/s
5,60 kg
2