Cleaning And Maintenance - BorMann Pro BAG2050 Manual

EN
Operating instructions
Always check that the power supply corresponds to the voltage on the rating plate.
Mounting and removing the guard (fig. A)
First remove the guard as described below.
Place the guard (7) on the machine as shown.
Tighten screw (8) firmly.
To remove the guard, proceed in reverse order.
Never use the machine without guard.
Mounting and removing a grinding wheel (fig. B)
Place the machine on a table, guard up.
Fit the spacer (9) onto the spindle (6).
Place the grinding wheel (10) on the spacer.
Screw the tension nut (11) onto the spindle.
Press the lock knob (5) and firmly tighten the tension nut (11) using the spanner (12) supplied.
Release the lock knob.
To remove the grinding wheel, proceed in reverse order.
Prior to mounting or removing a grinding wheel a ways unplug the tool.
Mounting and removing the side handle (fig. A)
• Tighten the side handle in one of the mounting holes.
Switching on and off (fig. A)
• To switch the tool on, keep the lock-off button (2) depressed and press the on/off switch (1).
• To switch the tool off, release the on/off switch.
Rotating the handle (fig. C)
The handle of this machine can be rotated into 4 different positions. The optimum position depends on the application.
• Pull the release knob to the rear and rotate the handle into the desired position
• Release the knob.

Cleaning and maintenance

The machine does not require any special maintenance.
Make sure that the ventilation openings are kept clean. Especially when working in a dusty environment.
Before removing dust a ways unplug the tool.
Do not use brushes of metal or similar tools to remove dust and avoid damaging the internal parts.
5
WWW.BORMANNTOOLS.COM