Cleaning And Maintenance; Technical Data - BorMann BDT1530 User Manual

EN
Warning! The spark guard protects your eyes and hands from sparks flying from the workpiece. Therefore, always use the spark guard.
Mounting and adjusting the workpiece support for the grinding wheel
• You must regularly adjust the workpiece support in order to compensate the wear of the grinding wheel.
• Hold the workpiece support (21) against the side of the wheel guard (9) and fit it using the bolts (22).
• Tighten the fasteners hand-tight.
• Adjust the distance between the workpiece support (21) and the grinding wheel (3) to the smallest possible value, with a maximum of 2 mm.
• Tighten the fasteners.
Mounting and adjusting the workpiece support for the grinding belt
• The workpiece support can be mounted at two different positions to the respective mounting eyes (23).
• Hold the workpiece support (24) against one of the mounting eyes (23) and fit it using the bolt (25) and the screw(26).
• Tighten the fasteners hand - tight.
• Adjust the distance between the workpiece support (24) and the grinding belt (6) to the smallest possible value, with a maximum of 2 mm.
• Tighten the fasteners.
Operating instructions
Before switching on the machine, check if all screws and nuts are tight and if the grinding belt can rotate freely.
Always grind on the front part of the grinding wheel or grinding belt.
Never overcharge the machine, causing the grinding wheel or grinding belt to come to a halt.
Use the grinding wheel for grinding metal tools. Regularly cool the tools to be cut with water.
Use the grinding belt for grinding wooden tools.
The machine is not intended for permanent use. Make sure that the machine is not overheated.
After using the machine for 30 minutes, let it cool down to ambient temperature.
Switching on and off
To switch the machine on, set the on/off switch (1) to 'I'. To switch the machine off, set the on/off switch (1) to '0'.

Cleaning And Maintenance

The machine does not require any special maintenance.
Regularly remove grindings from the housing and the covers.

Technical Data

Voltage/Frequency: 230V/50HZ
Input Power: 250W
No Load Speed: 2950RPM
Wheel Size: 150x20x12.7MM
Belt Size: 50x686MM
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes signif-
icantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer's product line with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is
used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
4
WWW.BORMANNTOOLS.COM