Technical Data - BorMann BBP5130 Manual

EN
Vibration levels. Hand held power tools produce different vibration levels. You should always refer to the specifications and the relevant Health and
Safety guidelines.
Dust extraction. If your tool is fitted with a dust extraction facility, always ensure that it is connected and being used with a dust extractor. Vacuum cleaners
can be used if suitable for the material being extracted.
Check damaged parts. Before use, any blade guard or other part that is damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that
may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorised service centre unless otherwise
indicated in this instruction manual. Have defective switches replaced by an authorised service centre. Do not use the tool if the switch does not turn it on and
off.
Have your tool repaired by a qualified person. Use of this electric tool is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user.
Safety Recommendations For The Correct Use Of Abrasive Products
General
Bonded abrasive products are breakable and shall therefore be handled with utmost care. The use of damaged or improperly mounted or used abrasive
products is dangerous and can cause serious injuries.
Delivery, handling and storage
Abrasive products must be handled and transported with care. Abrasive products must be stored in such a manner that they are not subjected to mechanical
damaged and harmful environmental influences.
Selection of the abrasive product
Information on the label or the abrasive product stating restrictions of use, safety indications or any other instructions must be followed. In case of doubt
concerning the selection of abrasive products, the user shall request information from the manufacturer or supplier.
Visual inspection and ring test
Abrasive products must be subjected to a visual inspection as received before mounting. In addition, a ring test shall be executed for vitrified wheels with
D>80mm. Damaged abrasive products shall be destroyed.
Mounting before starting and information for grinding
The mounting of abrasive products shall be carried out according to the instructions provided by both the wheel and the machine manufacturer. Mounting of
abrasive products must be carried out by a qualified trained person. After initial mounting, the wheel must be test run for a reasonable time - the specified
maximum operating speed of the wheel shall not be exceeded.
Description of main parts (Picture A)
1. Gearbox
2. Spindle lock button
3. ON/OFF Switch
4. Dust screen
5. Auxiliary handle
6. Safety guard
7. Locking Flange
8. Fast adjustment screw

Technical Data

Voltage: 20V
No-load speed: 10000rpm
Disk diameter: 125mm
Flange nut type: M14
Motor type: Brushless motor
Battery/charger: •1x4.0Ah Li-ion battery
•1x2.4A charger
Assembly and operating instructions
Installing the protection guard (Picture 1)
1. The guard should be positioned so as to protect the user and persons from particles, sparks and possible projections of pieces of the disc.
2. Once adjusted in the desired position, tighten the fast set screw so that the guard cannot be moved by hand.
Pic. 1
(A): Clamping lever
5
WWW.NIKOLAOUTOOLS.GR