Table of Contents
Advertisement
Error display
Remove dust from the air inlet/outlet at the bottom part of the main body.
●
●
Do not use the rice cooker on a soft surface such as paper, cloth, carpet,
plastic bags etc., or in a place where the air inlet/outlet is blocked.
●
Remove foreign objects such as rice grains adhered to the outer bottom
part of the inner pot and the temperature sensor.
●
Has too much water been added ? (Reduce the amount of water)
Are you using the same electrical outlet with other appliances ?
●
→ Use a 220 V AC outlet with a rating of 10 A or more. Do not share the
This error alerts you to prevent damage to some parts when high voltage is
●
applied.
●
Are you sharing an inner pot other than the specified one ?
→ Use the specified inner pot.
to
Contact the store from which the product was purchased in the following cases.
When you put rice or water directly into the cooker instead of the inner pot.
●
When you have damaged or lost the inner pot, inner lid, steam vent seal packing or power cord.
●
When any plastic parts or packing become damaged. (They may become damaged after several years of use.)
●
When a power failure occurs
After recovering from a power failure, the cooker will resume cooking rice or keeping it warm.
However, the cooked rice may not be tasty, the power may be cut off, or the preset finishing time may be delayed.
*
The same phenomena occur when you unplug the power plug or the circuit breaker is tripped.
Lithium battery
The lithium battery attached to the main body is used to work the clock when the power plug is unplugged, and memorize
cooking courses.
If the lithium battery is exhausted
When the power plug is unplugged, timer settings and memorized cooking courses are cleared.
To use the rice cooker, plug it in, and press the OFF key to stop the 0:00 display from flashing.
The cooker can then be used normally.
(Be sure to set the current time before using the timer.)
➡
To replace the battery, contact the store from which the product was purchased. (Cost borne by user).
The lithium battery is attached to the inside of the main body. Do not disassemble the main body.
You cannot replace it by yourself.
26
RC-DZ4K_EN_0722.indd
26
outlet with other appliances.
When "F13" is displayed, the KEEP WARM and START lamps flash and the buzzer sounds
continuously.
●
These displays indicate the malfunctioning of the printed circuits, temperature sensors, etc.
I mmediately stop using the cooker, unplug the power plug, and contact the shop from
which the product was purchased.
Unplug the power plug from an electrical outlet,
and take the following suited action(s).
Resetting the display
After taking the
recommended action(s),
plug in the power plug,
and press
(Error display is reset.)
Resume the operation after
cooling down the inside of
the body, inner pot and
inner lid.
key.
.
2016/07/22
16:33:33
Advertisement
Table of Contents
