RFI APM1317 User Manual page 37

APMxxxx Series User's Manual
ON:
The configured channel scanning On/Off status. If this is "OFF", the measurements for this channel will not be performed. This
field may be used if channels have been disabled or temporarily removed from the site.
Freq:
The configured frequency of the channel.
Act:
An "active" indicator that shows the status of the Last recorded power above threshold value being display.
The three states that may appear are;
The indicator symbol is displayed but is dull – the value shown was not measured in the last measurement cycle.
1.
The indicator symbol is displayed and is lit – the value shown was measured in the last measurement cycle.
2.
The indicator symbol is not displayed – the channel is currently disabled and is not being measured.
3.
Power:
The result of the last valid signal power level measurement in Watts and dBm. This will only be updated if the Tx power is above
the programmed minimum threshold level.
Ins Loss:
The last measured Combiner Insertion Loss value. This value is the difference between the current Power level (as above) and the
stored BTx Power level.
VSWR:
This is the VSWR recorded when the last valid power level measurement occurred.
Auto Refresh:
Check this box to enable continuously repeated measurement and status updates. Updates will refresh every 5 seconds.
Uncheck this box to cease continuously repeated updates.
Refresh:
Click this button to manually trigger one measurement and status update cycle.
Note: The field behind an alarm is highlighted in colour to indicate its current status.
White denotes 'no alarm', and Red denotes 'alarm'.
Asia Pacific | EMEA | Americas 37