Main View
•
The main view of Raymote display a list of the heaters
added in to your Raymote Organization.
•
Each heater is represented by a tile with its name and
an overview of the heater operation parameters.
USER AND ORGANIZATION
HEATER NAME
CURRENT WATER
TEMPERATURE
HEATER OFFLINE
HEATERS SCREEN
Heater Name
•
Heater name is defined during the Heater connection
and setup, but it can be changed anytime from the
heater settings.
Water Temp
•
The water temperature measured by the heater is
displayed in this field. Water Temp variates with the
ambient temperature, pumps and heaters operation.
Setpoint
•
Setpoint is the goal temperature for the heater. It can
be adjusted from the AVIA control board or directly
from Raymote.
•
Heater start a call for hear when Water Temp is 1
degree Fahrenheit or more, below the setpoint and
operation Mode is POOL or SPA.
•
Heater terminate heat when Water Temp is equal or
greater the setpoint temperature, or when Mode is
changed to OFF.
62
SETTINGS
INDICATOR
Figure 101. Main View - Heaters List
•
Raymote organization list can handle 1 or multiple
Commercial
and
equipped with Raymote.
Mode
•
Mode field displays the current operation mode
selected.
•
POOL mode use an independent setpoint.
•
SPA mode use an independent setpoint.
•
In OFF mode the heater is operational but is maintained
in standby until mode changes to POOL or SPA.
Offline Indicator
•
The offline indicator is displayed only when the Heater
can not be detected online.
•
Offline status can be cause by a heater disconnected
from power, WiFi signal weak or not available, or due
to any change in WiFi signal name or password.
•
Check the Connectivity Troubleshooting section for
details on how to recover or reconnect a heater to
Raymote.
Residential
Raypak
ADD HEATERS AND
SORTING
WATER TEMPERATURE
TARGET
HEATER MODE
SELECTION
HEATER LIST CAN
INCLUDE COMMERCIAL
HEATERS
OPENS AUTOMATION
SCREEN
OPENS NOTIFICATIONS
SCREEN
heaters