Table of Contents
Advertisement
2
Fig. 4: Exchange of the source - VEGASOURCE version A
1
Extension rod M8 (optional)
2
Key lock with key
3
Threaded pin
4
Retaining pin
5
Capstan screw (sealable)
6
Safety bolt - Source capsule (optional)
7
Cover plate
8
Source
9
Source holder
Required tools
Remove source holder
Source loading and exchange • VEGASOURCE 31, 35
2
Loading or source exchange
2.1
Version A
1
3
5
You need the following tools when exchanging the source on version
A:
•
Key for key lock
•
Hexagon spanner, size 5
•
Allen key, size 2.5 (optional)
•
Flat-headed screwdriver, size 1.5 x 10
•
Side cutters
•
Gripper tool or manipulator for source capsule
•
Possibly extension rod M8
•
Remove the protective cover - see operating instructions of the
source container
•
If necessary, screw an extension rod (1) with thread M8 into the
socket of the source holder. With this extension you can increase
the distance to the source
•
Unlock key lock (2) with key
•
With the version with density modification: Loosen pin (3) with an
Allen key size 5
•
Remove the seal between holding pin (4) and capstan screw (5)
with side cutting pliers and pull out the seal wire
•
Unscrew the capstan screw (5) with a flat headed screwdriver, size
1.5 x 10
4
2 Loading or source exchange
9
7
6
8
7
Advertisement
Table of Contents
