Repair
6.7 Replacing door latches and sensors
Required tools:
Magnet
Permanent magnet
The door latch is mounted on top of the tank and contains a magnet, not a microswitch.
A Hall effect sensor in the door senses the magnet when the door is closed.
Before replacing the latch or sensor, check if the latch is misaligned and cannot be
read by the sensor by checking the sensor with a magnet. If the dishwasher runs when
the magnet is held above the left screw of the sensor (see below), the sensor is OK --
adjust the door, door latch or door seal.
Fig. 78: Checking door latch sensor with a magnet
Prerequisite:
Door latch sensor checked with a magnet (see above).
6.7.1 Removing door latch Hall Effect sensors
Required tools:
Torx TX10 bit with hole, long
6.3 mm (1/4" ) 89 mm , for screws
with safety pin
Torx T20 screwdriver
Slotted screwdriver
Blade 4 mm x 0.8 mm x 100 mm, only
China
Prerequisite:
Power supply to dishwasher disconnected.
Outer door removed→ Page 79
Fascia panel removed→ Page 80
2020-04-24_58300000218396_ara_en_c
1. Disconnect wire harness from sensor.
2. To remove sensor, open door and remove (2) T10 Torx screws from the top center
of the door.
3. Install in reverse order.
6.7.2 Removing door latches
Required tools:
Pliers
Slotted screwdriver
[00341231]
Torx T20 screwdriver
When replacing a door latch:
[00341279]
¡
Make sure the door latch is aligned, is held securely and the sensor detects the
[00342443]
door latch magnet.
¡
Misaligned latches can prevent dishwashers from starting. If the dishwasher won't
start, check door latch alignment.
¡
Only disconnect and pull out dishwasher enough to clear door latch.
Prerequisite:
Dishwasher disconnected and pulled out→ Page 76
Copyright by BSH Hausgeräte GmbH
160 mm
Blade 2.4 mm x 0.4 mm x 60 mm, in
the kit [00341820]
[00341142]
[00341279]
Page 82 of 126