Electrical Connections; Making Electrical Connections - Bosch SHEM63W55N Repair Manual

Repair

6.31 Electrical connections

All electrical connections must be made according to national and local electrical
codes.

6.31.1 Making electrical connections

Required tools:
Phillips screwdriver PH2
All electrical connections must be made according to national and local electrical
codes.
6.31.1.1 To power module
The dishwasher cord plugs into the power module at the left rear of the dishwasher
base.
Prerequisite:
Dishwasher disconnected and pulled out→ Page 76
▶ Plug the power cord completely and securely into the back of the power module
until it "clicks".
Fig. 100: Power module connections
The plug has notches (1) to keep it plugged into the power module.
2020-04-24_58300000218396_ara_en_c
Fig. 101: Optional junction box [SMZPCJB1UC]
6.31.1.2
Power cords have been lengthened for difficult installations. To meet UL standards,
power cords must not be longer than 1.2 m (47.24") between the dishwasher base and
outlet (or junction box when the optional [SMZPCJB1UC] junction box kit is used).
To make sure power cords aren't further than 1.2 m (47.24") from the dishwasher to
the outlet or junction box, a self-adhesive clip has been provided to clamp cords to
bases 5" (127 mm) to the left of the rear foot adjuster.
1. Attach the clip pointing in one of two directions, depending on where the power
cord exits the dishwasher.
1. Left (viewing rear of dishwasher) – point the clip to the right.
2. Right (viewing rear of dishwasher) – point the clip upward.
Fig. 102: Using power cord clip
2. Measure the distance between the dishwasher base and outlet (for power cord) or
junction box (for optional junction box with cord) to make sure it's not longer than
1.2 m (47.24").
Copyright by BSH Hausgeräte GmbH
An optional junction box with cord, cord clip and strain relief is available
to replace the power cord provided with the dishwasher - [SMZP-
CJB1UC].
Using cord clips
Page 124 of 126