Test; Testing Components - Bosch SHEM63W55N Repair Manual

Test

Test

5.1 Testing components

These 8 to 9 tests (depending on the model) turn components on to test them.
¡
Components are tested in sequence (i.e. cannot be turned on individually).
¡
Heat pump test "S:03" runs for 10 minutes, enough time to check heater voltages.
You can skip the test when you're done or don't need to run it.
To save time, end CS test program early by pressing and holding the
"Start" button for 3 seconds (to reset dishwashers) and then turning dish-
washers off.
Prerequisite:
Dishwasher had been reset and turned off
1. While pressing and holding buttons "B" and "C", turn the dishwasher on. Release
buttons after "P0" is displayed.
Fig. 63: Entering CS program mode
2. Press button "B" once to select viewing error / fault codes. To select CS test pro-
gram, press button "B" repeatedly to scroll through selection(s) until "P1" is dis-
played.
3. After making your selection, press button "C" to start it, whether viewing error
codes or running tests.
Fig. 64: Starting test sequence
Notes for running the first 8 to 9 tests (depending on the model) of the CS test
program:
– Test sequences start at S:00 and scroll through to the end, often through
S:72.
– Press button "B" to skip heat pump heater test S:03 - can't skip other tests.
– To resume test sequences after they've been skipped (for heat pump test
S:03), press and hold "Start" button for 3 seconds (resetting dishwashers).
– Depending on model features, water softener regeneration test S:05, emo-
tion light test S:06 and / or door opening test S:10 could be omitted.
2020-04-24_58300000218396_ara_en_c
4. Check component operation by running the first 8 to 9 tests (depending on the
model) of the CS test program below:
Test
Preparing
dishwasher
Filling
Heat pump
motor
Heat pump
heater
Water inlet
valve
Dispenser
Water switch
Drain pump
5. To stop or exit tests:
1. To stop or exit viewing error codes, simply turn the dishwasher off.
2. To stop running tests or exit the test mode after tests have ended, press and
hold the "Start" button for 3 seconds (to reset dishwashers) and then turn dish-
washers off.
Copyright by BSH Hausgeräte GmbH
Display Duration Action
S:00 60 s -
S:01 3.5 l -
S:02 10 s -
S:03 600 s Can skip test
S:04 2 s -
S:07 2 s -
S:08 ~ 15 s -
S:09 60 s -
Notes
Drains all wa-
ter and stops
water switch at
lower rack
Heat pump
runs slightly to
purge air
Runs at 3000
RPM
Heats at 2ºF /
minute for 10
minutes
Turns valve on
and off
-
Stops at upper
rack
Drains all wa-
ter
Page 61 of 126