Flipping Dishwashers - Bosch SHEM63W55N Repair Manual

Repair

6.3 Flipping dishwashers

Required tools:
Torx T20 screwdriver
Phillips screwdriver PH2
Long screwdriver
Gloves Protective gloves
Follow these instructions to flip dishwashers onto their backs for bottom access.
Prerequisite:
Dishwasher disconnected and pulled out→ Page 76
Toe panel removed→ Page 87
Outer door removed→ Page 79
Base cover removed→ Page 88
Dishwasher completely slid out from under countertop.
Base insulation removed (on models with front / rear base insulation).
All water removed from dishwasher sump and hoses.
1. Remove both racks.
2020-04-24_58300000218396_ara_en_c
2. Remove the two (2) rear base screws.
[00341279]
3. Release door spring tension by disconnecting both hinge cords from their hinge
levers and parking cords onto the base.
1. To park the hinge cords onto the base, open the door and place the hinge
cord notches onto the base housing flange. Close the door to slide both hinge
levers out from hinge cords.
2. If parking hinge cords isn't sufficient (to release spring tension), remove both
door spring clips, door springs and cords from the base.
Copyright by BSH Hausgeräte GmbH Page 77 of 126