Replacing Outer Doors - Bosch SHEM63W55N Repair Manual

Hide thumbs Also See for SHEM63W55N:

Table of Contents

Repair

6.4 Replacing outer doors

Required tools:

Torx T20 screwdriver

Removing the outer door is needed for front access and for bottom access / flipping

dishwashers on their backs. For most dishwashers, the short bottom six (6) screws

hold outer doors.

Danger

Risk of electric shock due to live parts!

Death by electrocution

▶

Disconnect appliances from electrical supply at least 60 seconds

before starting repairs.

Prerequisite:

Power supply to dishwasher disconnected.

1. Remove six (6) short T20 Torx inner door screws below fascia panel – three per

side (below).

2020-04-24_58300000218396_ara_en_c

[00341279]

Carefully pull bottom of outer door out from dishwasher until top door tabs clear,

then pull door down until it releases from dishwasher (below). Take care to not

scratch outer door.

3. Install in reverse order.

Notice

Cutting wire harnesses while removing / installing outer doors.!

Causing short circuits that can damage controls or cause electric

shock.

▶

Remove / install outer doors carefully to insure harness wires

and insulation aren't cut.

▶

After removing outer doors, check wires and insulation to

make sure they're not cut or pinched. Carefully retape har-

nesses as needed to eliminate any slack.

Page 79 of 126

Table of Contents