Installing Sumps - Bosch SHEM63W55N Repair Manual

Repair
3. Remove four (4) sump screws from inside of tub.
4. Lift sump from dishwasher tub.

6.26.2 Installing sumps

To make sure the sump is seated properly onto the tub, the dishwasher must be right
side up during sump installation and the following steps must be followed. Once the
sump is properly installed, other parts (e.g. heat pump, water switch) can be installed
with the dishwasher upright or on its back.
Fig. 98: Sump view (under tub)
2020-04-24_58300000218396_ara_en_c
1. Install drain check valve.
If replacement sump doesn't have one.
2. Install aqua sensor.
3. Install water switch.
4. Place dishwasher right side up.
5. Lay the sump loosely onto the base where it would be in its final position.
In other words, lay the sump onto the base right side up, centered under the
tub cutout in a position to be reconnected to the heat pump and hose.
6. Lift the dishwasher onto the base and reconnect the base to the tub using the two
(2) front latches and two (2) rear base screws.
7. Using one hand, carefully lift the sump up to the tub. Use the hand you won't be
using to screw in sump screws.
8. Using your other hand, insert screws in the order shown below, starting at the top
left screw and going cw (clockwise) around the sump to use the screws to raise
the sump to the tub.
Copyright by BSH Hausgeräte GmbH
For easier installation, coat aqua sensor o-ring with rinse-aid.
Installation hints:
¡ For easier installation, coat water switch o-ring with rinse-aid.
¡ Do not reconnect heat and drain pumps until later.
Page 115 of 126