Buffalo TS6400DN0802 User Manual page 15

Chapter 1 Getting Started
11
Drive Lock
Open the front panel with the key to replace drives or access the init button.
12
Init Button
Press and hold down this button to initialize the TeraStation's admin username and password, IP settings, SSL,
and service port restriction settings to their factory default values. The effects of this button can be changed in
Settings.
13
Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red.
14
Fan
Spins to prevent overheating inside. Do not block the fan.
15
Not in use.
16
USB Port
Compatible Buffalo USB drives, USB memory devices, and USB UPS connections can be connected. USB hubs
are not compatible.
17
LAN Port 1 (1GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
18
LAN Port 2 (1GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
19
LAN Port 3 (10GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 10 Gbps
if using the included Ethernet or category 6A cable.
Note: To communicate at up to 10 Gbps, all network devices must be compatible with 10GbE.
20
Power Connector
Use the included power cable to connect to a UPS, surge protector, or outlet.
21
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
22
Serial Number
This sticker shows the TeraStation's serial number.
23
UID Button
Press this button to cycle the blue LED on and off.
24
Link/Act LED
Glows green when the TeraStation is connected to a network. It blinks when the connection is active.
25
Link/Act LED
Glows amber when the TeraStation is connected to a network at 100 Mbps. It blinks when the connection is
active.
14