Table of Contents
Advertisement
Chapter 7 Advanced Features
2
From Settings, click Management.
3
Click the settings icon (
4
Select "Create a USB drive for initializing settings".
5
From "Target USB Drive", select the USB drive that is connected to the USB port on the TeraStation, then click
Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
The TeraStation will create the initialization drive. This will take about a minute. When creating the USB
initialization drive is completed, refresh the browser and log in to Settings again.
Initializing with the USB Drive
To initialize the settings on your TeraStation with the USB drive as created above, follow the procedure below.
Note: If using the initialization drive to initialize, the unit's current firmware version will be changed to the version
used to create the initialization drive.
1
Turn off the TeraStation by pressing and holding down the power button for three seconds.
2
Insert the USB drive into a USB port on the TeraStation. Make sure that no other USB drives are currently
connected to any USB ports on the TeraStation.
3
Power on the TeraStation while holding down the function button.
4
When the I41 message appears on the LCD panel, press the function button.
5
The TeraStation will initialize the settings. The I37 message will appear on the LCD panel when initializing
settings. When the initialization is completed, the TeraStation will restart automatically.
Dismount the USB drive before unplugging it. Refer to the
procedure on dismounting drives.
) to the right of "Configuration Management".
192
"Dismounting Drives"
section in chapter 4 for the
Advertisement
Table of Contents
