Table of Contents
Advertisement
Chapter 1 Getting Started
TS6400RN
13
14
1
Power Button
To power on, connect the power cable and wait for 10 seconds, then press the power button. To power off,
press and hold down the power button for three seconds.
If the TeraStation beeps, pressing this button for a short period will stop the beeping.
2
Power LED
When the TeraStation is on, the LED glows green.
3
Info LED
If there is a status message, the info LED will light up amber. Check the LCD panel to see the status message.
4
Error LED
If there is an error, the error LED will light up red. Check the LCD panel to see the error message.
5
LAN1 LED
When LAN port 1 is connected, this LED glows green. It blinks when the connection is active.
6
LAN2 LED
When LAN port 2 is connected, this LED glows green. It blinks when the connection is active.
7
LAN3 LED
When LAN port 3 is connected, this LED glows blue. It blinks when the connection is active.
8
LCD Panel
This display shows the status of many TeraStation settings. It also displays errors and messages when available.
9
Display Button
Press to switch between the different display modes. Also, if the TeraStation is beeping, press this button to
stop it.
10
Function Button
Use this button for dismounting USB devices, rebuilding RAID arrays, configuring failover, stopping the
TeraStation's beeping, and initializing settings using a USB drive.
22
13
23
3 4 5 6 7 13
24
15 23 16 17 18 19
1
8
9
10
25
26
27
21
13
13
12
16
20
14
Advertisement
Table of Contents
