Jøtul GF 520 DV Installation And Operation Instruction Manual page 9

Mobile Home Installation
The GF 520 DV is approved for installation in a mobile home in
the U.S. and Canada with the following requirements:
 The stove must be secured to the floor of the mobile home.

Provision must be made to secure an electrical ground
between the stove and the mobile home chassis.

The stove must be installed in accordance with Title 24 CFR,
Part 3280-Manufactured Home Construction and Safety
Standard in the U.S.
In Canada, comply with CSA Z240.4, Gas Equipped
Recreational Vehicles and Mobile Housing.

Always contact your local officials about installation
restrictions and requirements in your area.
Procedure
1. Using the two #12 x 3 1/2" screws used to secure the stove
to the shipping pallet, secure the GF 520 DV to the floor
of your mobile home through the two holes at the bottom
of the base of the stove. If needed, longer hardware can be
used.
Shipping/Mobile Home Screws
Figure 5.4
Mobile Home Installation
THIS APPLIANCE MAY BE INSTALLED AS AN
OEM INSTALLATION IN A MANUFACTURED
(MOBILE) HOME AND MUST BE INSTALLED IN
ACCORDANCE WITH THE MANUFACTURER'S
INSTRUCTIONS AND THE MANUFACTURED
HOME CONSTRUCTION AND SAFETY
STANDARD, TITLE 24 CFR, PART 3280. THIS
APPLIANCE IS ONLY FOR USE WITH THE TYPE
OF GAS THAT IS INDICATED ON THE STOVE'S
RATING PLATE. A GAS CONVERSION KIT IS
PROVIDED WITH THE GF 520 DV GAS STOVE.
THIS APPLIANCE MAY BE INSTALLED IN AN
AFTERMARKET PERMANENTLY LOCATED,
MANUFACTURED (MOBILE) HOME, WHERE
NOT PROHIBITED BY LOCAL CODES.
Figure 5.5
Mobile Home Installation
130139_Rev 1 GF 520 DV 12/22
9