Connection - Eneo IND-32F0016P0A Quick Installation Manual

Connection

The camera has the following cables:
1� RJ45 Network Interface:
Connect to a router or switch on your network using RJ45 Ethernet cable (Cat5e
or better)� 100MHz connection, PoE supported (class 3 PoE switch or injector as
required)
2� Alarm Terminal Block
3� Reset Button: recessed button inside
4� DC Power input (DC12V (600mA): 12V DC power input terminal)
5� BNC Video Output: Service Video
Note:
• Make sure to follow correct polarity (+/-) as marked on the power connector�
• Use DC power if no PoE is being used�
• PoE power is Class 3 for the device�
Alarm connections and Audio are supported� If required, connect audio using standard RCA
style mono connections� Alarm connection block can be removed for convenient attachment
of alarm input�
Note:
• Audio input and output is 1V line level�
• Additional amplification is required to drive speakers�
• Audio input whould not work directly with a simple microphone� Typically microphones need a
pre-amp to bring the voltage level to line level�
10