Removing The Throttle; Battery; Battery Sleep Mode - Igo ASPIRE CAMILLIEN CE Owner's Manual

12
iGO DRIVE

REMOVING THE THROTTLE

The throttle can easily be removed from the eBike if required
for Class 1 riding by following these steps :
Locate the throttle weatherproof twist connector (orange connection).
Unscrew the twist connect and gently pull to disconnect the throttle cable.
Loosen the securing bolt located under the throttle using a 3mm Allen key.
(Loosen the bolt enough to be able to freely manipulate the throttle
but not so much that the bolt falls out of the housing).
The handlebar grip will need to be removed in order to slide the throttle assembly off the end
of the handlebar. Ensure that the grip is reinstalled securely as an important safety precaution.
To re-install the throttle, repeat these steps in reverse while taking care to
properly line up the pins in the connection before applying any pressure.

BATTERY

All iGO batteries are secured to the bike frame using a barrel lock mechanism. The
battery can be removed from the frame for charging, storage, or when leaving the
bike in a public area by using the keys provided with the bike. Keys should always
be removed from the bike before riding. KEEP YOUR KEYS IN A SAFE PLACE.
It is advisable to keep a note of your key number with this manual for future reference.
The key number can be found on a metal tag attached with the keyring.
The iGO premium eBikes batteries utilize a smart Battery Management System (BMS).
This advanced technology provides increased safety features, additional diagnostic
information, statistical usage analysis, and greatly simplifies maintenance/care
procedures. Diagnostics and battery analysis information can be accessed
through the display unit and when using the iGO Ride mobile app. Safety and
maintenance features are automatic and require no setup from the user.

BATTERY SLEEP MODE

This automatic battery protection feature provides increased safety
during storage and simplifies battery care to optimize performance
while maximizing and even extending battery lifespan.
When the eBike has not been used for an extended period of time the battery will
automatically enter a sleep state preserving and protecting the battery cells.
The eBike electrical system will appear to be unresponsive when
the battery is in the dormant state. This is normal.
The table below indicates the combination of events that
will trigger the battery to enter the sleep state.
When charge level is : Battery will enter dormant (sleep) state after :
80% or more -
40% - 79% 30 days
10% - 39% 14 days
1% - 9% 48 hours
less than 1% 10 mins
To wake the battery :
Remove battery from the eBike and plug directly into the provided charger for
approximately 30 seconds. Locate and press the power meter button for 3-5
seconds until the power indicator LED lights up. This indicates the battery has
been reactivated and can be replaced into the eBike for immediate use.
13