Igo ASPIRE CAMILLIEN CE Owner's Manual page 20

38
MECHANICAL COMPONENTS
for : OUTLAND CABOT RS | OUTLAND SAWBACK RS
Q-LOC assembly
1. Check the segmented flange is expanded before installation. Open the lever completely.
2. Slide in the axle until it "clicks". Make sure the segmented flange is expanded.
3. Set the tension of the nut until the flange is flush with the dropout.
4. Close the lever completely. Check if it's firmly seated. Re-tighten the nut if necessary.
Q-LOC removal
1. Open the lever completely.
2. Press and turn adjust nut clockwise until segmented flange retracts and stays latched.
3. Pull out the axle.
for : DISCOVERY YORKVILLE LS | DISCOVERY ROSEMONT LS | OUTLAND TORNGAT RS
Axle assembly for front 15mm thru-axle
1. Position your front wheel into the dropouts of the lower fork leg. As you
are installing the front wheel, be sure to squarely position the brake rotor
in between the brake pads of the disc caliper. The hub shoulders should
seat squarely and firmly in the dropout counterbores.
2. Insert the axle into the left side of the fork dropout and slide it all the way
through the hub, until you contact the axle nut on the other side.
3. Using a 6mm Allen key, thread the axle into the axle nut five to
six (5-6) complete turns and tighten to 10-15Nm.
PUSH
TURN
Q-LOC FLANGE
PUSH
TURN
_
+
39
PUSH
TURN