Identify The Battery (Discovery & Outland); Remove / Install Battery (Discovery & Outland) - Igo ASPIRE CAMILLIEN CE Owner's Manual

14
iGO DRIVE
IDENTIFY THE BATTERY (DISCOVERY & OUTLAND)
The battery for the Discovery and Outland eBikes has the following features :
POWER METER
CHARGING PORT
On frame battery charging port
The frame charging port is located on the top left side of the down tube (non-drive side).
Lift the charger port cover to gain access to the port to charge
the battery when it is installed in the bike.
POWER METER BUTTON
REMOVE / INSTALL BATTERY
To remove the battery from the bike frame first remove the battery
cover under the battery tube by pushing down on the top latch and
tipping the top edge down on an angle, then lift and remove.
Insert the key into the lock but do not turn at this time. Support the battery with one
hand & use the other to turn the key 90˚ clockwise to the unlock position. While holding
the battery parallel to the frame carefully allow the battery to drop out of the frame.
To reinstall the battery, insert the key into the battery lock but do not turn at this time. Hold
battery parallel to frame and line up the battery with the receptacle. Insert the bottom portion
of the battery first, and then with one hand turn the key 90˚ counter clockwise to the unlock
position. Push the top part of the battery into the receptacle until you hear the latch close
onto the battery. At this point the battery will hold itself in place. With both hands on each side
of the frame and thumbs under the battery case push the battery to make sure its locked and
secure.
Reinstall the battery cover by inserting the tab on the bottom part of the battery cover into the
slot located under the battery. Once inserted tilt the cover and latch into place.
Always lock battery & remove the key while riding.
REMOVE BATTERY COVER
SUPPORT BATTERY AND TURN KEY
INSERT KEY
CAUTION
When the key is turned the battery lock
will be released. The battery must be
supported to aviod falling from the frame.
15